Installation Guide

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with your packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the needed parts are included in the package by checking off the components

on the “Detailed Diagram of Shower Door Components”. If the unit has been damaged, has a

finishing defect, or has missing parts, please contact our customer support department within

3 business days of the delivery date. Please note that DreamLine

will not replace any

damaged products or missing parts free of charge after 3 business days or if the product

has been installed. Feel free to contact DreamLine

if you have any questions, and please

provide an order number, job name or other proof of purchase to help us identify your original

order.

2. Please note that you should consult your local building codes with questions about

installation compliance standards. Building and plumbing codes may vary by location, and

DreamLine

is not responsible for code compliance standards for your project and will not

accept any returns.

3. If this unit is going to be installed in a new construction, please install all of the required

plumbing and drainage before installing the shower. Use a competent and licensed (if required

by local code) plumber for all plumbing installation.

4. Please make sure that prior to beginning the installation, the surfaces are leveled and solid and

will be able to support the total weight of the unit. Also make sure the walls are at right angles.

Irregular installation surface level, radius corners or improper angle of side walls will result in

serious problems for your installation. Please, note that some adjustments and drilling may be

necessary during the installation process.

5. Please protect all primary surfaces of the product during installation. Never set your glass down

directly onto a tile floor. Leave corner protectors in place until necessary to remove them.

Always use a piece of wood or cardboard to protect the bottom edge and corners of the glass

prior to and during installation.

6. This unit must be installed upon a finished threshold and against finished walls.

7. This model has 4” of total width adjustment: including 1/2” of adjustment per wall profile for out-of-

plumb wall conditions plus 3” of overall width adjustment with the expanding top and bottom rails.

Be sure that you have ordered the correct model size to fit your finished opening.

8. This model requires a minimum 1-3/8” of flat threshold space for installation.

9. Professional installation recommended.

NOTE: This door is reversible for right or left-hand door installation. The right-hand door installation is

shown as an example throughout this manual.