Installation Guide

14. Attach the Flanged Anti-water strip (07) to the vertical edge of the

Stationary glass.

Open the door and attach the Bottom Anti-water strip (08) to the

bottom of the door glass from the pivot to the edge of the magnetic

strike rail and trim off the excess. Next, attach the cut off to the

bottom of the door glass, opposite of the pivot and trim to fit.

Attach both pieces of the Bottom Anti-water strip (08) to the

bottom edge of the Glass door.

See Fig. 17 for details.

15. Apply a good quality, mildew-resistant silicone along

the wall profiles and the bottom expanding rail

where they meet the walls and threshold from both

inside and outside the shower.

Allow 24 hours for the silicone to fully cure before

first use.

See Fig. 18 for details.

Caulk

Fig. 17

Fig. 18

outside

NOTE: Measure to the strike edge of the

door and notch the Bottom anti-water

strip (#08) with a razor knife to fit around

the magnet strip, leaving the bottom

sweep intact.