Full Product Manual

“MIRAGE - 48” Rev. 2 Ver. 4 07/2013 13

15. Locate the Support bar (05) and temporarily fasten

it to the Sliding bracket assembly (09) with the

Head screw M6×8 (H). 

Adjust the bar to a proper position and level it

horizontally. Hold it firmly and outline the wall

bracket of the Support bar to mark wall with

position.

Remove the Support bar and detach its wall bracket.

Place the wall bracket of the Support bar against its

outlined position on the wall and mark the hole for

drilling.

Drill the hole using Ø 5/16” drill bit, insert the Wall

anchor (06) and fasten the Support bar’s wall

bracket to the wall with the Countersunk screw

ST4.2×40 (16).

Attach the Support bar back to its wall bracket and

Sliding Bracket assembly and tighten the screws to

secure the glass.

See Fig. 17 for details.

Fig. 17

16. Apply the sealant along the connection of

Stationary glass (01) with the wall inside the

shower, as well as between the Guide rail (03) and

the threshold outside the shower.

See Fig. 18 for details.

Fig. 18

Ø 5/16"

caulk