Installation Guide

Table Of Contents

“Enigma Z” Rev.1 Ver.1 05/2013

11. Parallel the Stationary glass (02) to the shower base or

threshold. Measure the distance from the side wall to the

far edge of the Guide block (12).

This distance will be “X”.

Cut the Anti-splash threshold (15) to the size of X−½”.

Insert one side of the Anti-splash threshold fully into the

Guide block and cover the other side with the Threshold

bracket (16).

Parallel the Anti-splash threshold to the front edge of the

shower base or threshold and mark the drilling hole

through the Threshold bracket.

See Fig. 13 for details.

Fig. 13

12. Drill the holes for the Guide block (12)

and the Threshold bracket (16) using

Ø 1/8” drill bit.

Apply silicone to the bottom of the

Anti-splash threshold (15) and place

it back into the designated position.

Fasten the Guide block and the

Threshold bracket to the shower base

or threshold with the Round head

screw ST4.2×25 (17).

Cover the hole with the provided

decorative plug.

See Fig. 14 for details.

Fig. 14

X-1/2"

Ø 1/8"