Installation Guide

Ver. 2, Rev. 1
6
4. Place the Threshold (02) in the desired
position and parallel to the front edge of
the Shower base or the Tub.
Measure the distance from the front
edge of the Threshold to the far corner
of the wall. This distance is “X”.
(you will need this distance for Step 6
)
Mark the drill holes through the
predrilled holes at both ends of the
Threshold.
See Fig. 5 for details.
Fig. 5
5. Drill the holes in the Shower base or
the Tub using Ø 1/8” drill bit. Apply a
layer of caulk or silicone to the
bottom side of the Threshold (02)
and secure it to the Shower base with
the Round head screw ST4.2×25
(07).
Cover the screw holes with the
Decorative covers for Threshold
(15).
See Fig. 6 for details.
Fig. 6
X
Ø1/8"
Ø1/8"
Caulk
1
2
3
5
4