Installation Guide

8ENCORE shower and tub door manual Ver 1 Rev 5 05/2018

Fig 4b

3 42

Ø5/16”

(8mm)

Fig 4a

TIP: Add a few drops of

dish soap to the screws to

make installation easier.

4. Attach the Upper Guide Rail Connectors (#07) to one end of both Wall Profiles (#01) using the

ST4.2 x 30 Truss Head Screws (#13). (Fig 4a)

Position one Wall Profile (#01) against the wall tight to the threshold and over the Bottom Guide

Rail (#15). Check for plumb with a level and mark the position. Mark both holes for drilling on the wall

through the holes in the Upper Guide Rail Connector (#07). (Fig 4b)

Remove the wall profile and drill Ø5/16” holes and insert the Wall Anchors (#09). (Fig 4a and 4b)