Installation Guide

9ENCORE shower and tub door manual Ver 1 Rev 5 05/2018

Fig 5b

Fig 5a

Painter’s Tape

TIP: Secure the wall profile to the wall with several

strips of painter’s tape or similar to hold it tight in

position until the silicone cures.

5. Apply silicone to the back of the Wall Profile (#01)

and place it back onto the marked position on the wall.

Attach the Upper Guide Rail Connector (#07) to the

wall using two each of the ST4.2 x 40 Countersunk

Flathead Screws (#10).

Attach two of the Wall Profile Bumpers (#04) using

the ST4.2 x 10 Screws (#11) and cover the holes with

the decorative caps. (Fig 5a and 5b)