Installation Guide

ENCORE shower and tub door manual Ver 1 Rev 5 05/2018

Painter’s Tape

TIP: Use several strips of painter’s tape (or similar)

to hold the bottom guide rail tight to the threshold

until the silicone cures.

Fig 6

Fig 7

Ø1/8”

Ø5/16”

The bottom rail must be screwed to the

threshold or tub deck. Any questions

regarding the drilling into a threshold or

tubdeck should be directed to

the manufacturer of that product.

6. Position the Bottom Guide Rail (#15) back

onto the threshold and mark the threshold

through the Guide Block (#05) holes for drilling.

Remove the Bottom Guide Rail (#15) and

drill into the threshold:

◾Drill Ø1/8” holes for installation into an acrylic

threshold

◾Drill Ø5/16” holes and use anchors for

installation into a tile threshold. (Fig 6)

7. Apply silicone to the bottom surface of the Bottom Guide Rail (#15) and place it back into position

on the threshold. Attach the Guide Block (#05) and Bottom Guide Rail (#15) to the threshold using

two of the ST4.2 x16 Screws (#12) and cover the screw holes with the decorative caps. (Fig 7)