Installation Guide

12ENCORE shower and tub door manual Ver 1 Rev 5 05/2018

Fig 10

Painter’s Tape

Fig 9

TIP: Secure the wall profile to the wall with several

strips of painter’s tape or similar to hold it tight in

position until the silicone cures.

10. Install the Upper Guide Rail (#02) onto the installed Wall Profiles (#01).

Make sure that it sits firmly onto the Upper Guide Rail Connectors (#07) and is level across the

opening. (Fig 10)

9. Apply silicone to the back of the Wall Profile (#01) and place it

back onto the marked position on the wall. Attach the Upper Guide

Rail Connector (#07) to the wall using two each of the ST4.2 x 40

Countersunk Flathead Screws (#10). Attach two of the Wall Profile

Bumpers (#04) using the ST4.2 x 10 Screws (#11) and cover the

holes with the decorative caps. (Fig 9)