Installation Guide

15ENCORE shower and tub door manual Ver 1 Rev 5 05/2018

To adjust the Door Glass with the rollers:

• Remove the cover plate

• Loosen the roller attachment bolt

• Rotate the adjustment bolt:

CCW to raise or CW to lower -

DO NOT remove the bolts or fully

disassemble the rollers.

Fig 15

Fig 16

outside

shower

Cover plate /

Mounting bolt

Loosen or

tighten the

Adjustment

Bolt

cover plate

mounting bolt

(Do Not remove)

Use the adjustment bolt on the roller

assemblies to adjust the door glass so

that it closes evenly into the wall

profiles

Adjustment bolt

(Do Not remove)

Do Not allow the door glass to make contact

with the bottom guide rail.

16. Install both the inside and outside Towel Bars (#08)

using all of the provided gaskets as shown. Cover the exposed

bolts with the decorative caps. (Fig 16)

15. To compensate for minor out-of-plumb conditions

(up to 3/8”): After both doors are installed, use the Allen

Wrench (#14) to make minor adjustments with the

Adjustment bolts on the Roller Assemblies (#06).

Remove the cover plate, then loosen the mounting bolt on

the roller. Rotate the adjustment bolt on the bottom of the

wheel assembly to tilt the door glass to the desired

position. Re-tighten the mounting bolt and replace the

cover plate. (Fig 15)