Manual

“PRIME” Enclosure Ver.1 Rev.3 12/2015
10
12. Apply a good quality mildew-resistant silicone sealant
along the profiles and guide rails; on the seams between
the bottom guide rail and the profiles as well as along
the shower base or threshold from the inside of the
shower area. You may also apply silicone along the
outside if you choose.
See Fig. 11 for details.
Fig. 11
Product Maintenance
BASES and BACKWALLS: To ensure a long life for your acrylic back walls: wipe them off after
each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based
cleaners. Never use abrasive cleansers, metal brushes or scrapers that could scratch or dull the
surface.
GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use
with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent
soap buildup and water spots. To prevent scratching the surface: never use abrasive cleaners and
cleaning products that contain scouring agents. Never use bristle brushes or abrasive sponges.
HARDWARE: To ensure a long lasting finish: wipe off the metal parts after each use with a soft
cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If
accidentally used, rinse the surface as soon as possible to prevent finish peeling or corrosion. After
cleaning the shiny finishes, rinse thoroughly and wipe dry with soft cloth. Never use abrasive
sponges or cloth, steel wool or wired brushes as these may permanently scratch the surface.
Caulk
Allow 24 hours for the silicone to fully cure
before using the shower.
Follow the safety guidelines from the Sealant
manufacturer concerning application, proper
ventilation and cure time.