Installation Instructions

Rev 1.6

9. Move the finished frame to the designated

position on the shower base, the bathtub or the

threshold (depending on your installation); push it

against the walls. If your top and bottom wall

opening measurements are different or if the

walls are out-of-plumb, make adjustment by

slightly pulling the Wall profiles (02) out of the

Glass Profiles (01).

Use the level to adjust the frame in the vertical

position

See Fig. 9 for details.

Fig. 9

10. Using help to hold this assembly in the right

position, mark the drill holes on the wall through

the holes on the flange of the Wall Profiles (02).

11. Gently set the assembled unit aside; drill the holes

using Ø 5/16” drill bit and insert the Wall anchors

(15).

Apply silicone caulk along the Wall profiles and

around the holes on the wall. Also apply silicone

under the bottom Guide rail (03). Place the whole

shower assembly back into the designated position

and secure it to the walls using the Round head

screws ST4.2×30 (10).

See Fig. 10 for details.

Fig. 10

Ø5/16”