Installation Instructions

“INFINITY Z” Rev.2 Ver.2 04/2013
5
Fig. 3
3. If the Guide rails (03) have been cut, you will need to
reinstall roller stopper on each Guide rail on the side
that has been cut.
Remove existing stopper. Mark the drilling hole with
a distance of 3 1/8” from the cut off edge of the
Guide rail.
Drill the new holes using Ø1/8” drill bit; then secure
the stopper with screw.
ATTENTION:
Do not drill the Guide rail throughout, only the
first layer.
See Fig. 4 for details
Fig. 4
1
2
Ø 1/8”
3 1/8”