Installation & Assembly

Q-Wall 4 manual Ver 1 Rev 2 08/2015
5
2. Measure the walls of the shower from the
1” (one inch) line in the corner (from
Step. 1) to the points where you want
Side panels (01) to end.
The distances are “D1” and “D2”.
NOTE:
“D2” Shows wall with the fixture.
See Fig. 3 for details.
Fig. 3
3. Determine the position of both
Side panels (01).
NOTE:
a) The narrow edge of the Side
panels fits behind the corner
cover and cannot be trimmed.
b) The wide edge of the Side
panel can be trimmed to the
size of your measurements
from step 2.
Measure from the narrow edge of
the Side panel and place a mark
at a distance of “D1” and “D2”
(that you measured in Step 2).
Draw a straight line from top to
bottom along the wide edge of
the Side panel.
See Fig. 4 for details.
Fig. 4
D1
D2
D1
D1
D2
to cut
Line
to cut
Line