Installation & Assembly

UNIDOOR Single Shower Door manual Ver 2 Rev 6 02/2018

Single Shower Door Assembly and Installation

NOTE: The following shower door installation instructions should be used as a general

guide and prerequisite to the installation of the UNIDOOR, UNIDOOR-LS, UNIDOOR LUX

and UNIDOOR PLUS models. Before you begin the installation, please check your finished

opening size. Specific size information can be found on DreamLine.com

1. Attach the Hinges (05) to the Door Glass (01). Use one hinge

gasket per side. Attach the hinges centered in the notches and

square with the edge of the door glass. Fully tighten the hinge

bolts. (Fig 1)

Never set your glass down directly

onto a tile or concrete floor.

Always use a piece of wood or cardboard

and leave the corner pads and protective

shims on the glass until it becomes

necessary to remove them. This will

protect the bottom edge and corners

from damage which could lead to

breakage.

ATTENTION:

For Styles E, I, J & L that have return panels:

Please check the model dimensions for proper placement of the Door Glass (01) so that the

door glass will align correctly with the return panel glass.

Fig. 1

ATTENTION:

This door is extremely heavy and

the hinges on this door must be

installed into studs or to

preinstalled 2×6 wood

reinforcement behind the wall.

inside

outside

NOTE: DO NOT attach the handle to the

door glass until instructed.

DO NOT use the handle to lift the glass

during installation. This may result in damage

to the glass and/or serious injury. Always use

an assistant or a professional grade glass

suction cup when handling the door glass.