UNIDOOR (STYLE G) SHOWER DOOR GLASS PANEL INSTALLATION INSTRUCTIONS IMPORTANT DreamLine® reserves the right to alter, modify or redesign products at any time without prior notice. For the latest up-to-date technical drawings, manuals, warranty information or additional details please refer to your model’s web page on DreamLine.com Style G Left hand installation shown Please read these instructions carefully before installing.
Model #s SHDR-24232434-## SHDR-24232436-## SHDR-24233634-## SHDR-24233636-## SHDR-24242434-## SHDR-24242436-## SHDR-24243634-## SHDR-24243636-## SHDR-24273034-## SHDR-24273036-## SHDR-24273634-## SHDR-24273636-## SHDR-24283034-## SHDR-24283036-## SHDR-24283634-## SHDR-24283636-## SHDR-24293034-## SHDR-24293036-## SHDR-24293634-## SHDR-24293636-## SHDR-24303034-## SHDR-24303036-## SHDR-24303634-## SHDR-24303636-## Style G ## = finish 01 – Chrome 04 – Brushed Nickel 06 – Oil Rubbed Bronze “UNIDOOR (STYLE
Preparation 1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece count with your packing slip. After opening all boxes and packages read this introduction carefully. Check that all of the needed parts are included in the package by checking off the components on the “Detailed Diagram of Shower Door Components”.
Tools Required Caulk Level Tape Measure Caulk Gun “UNIDOOR (STYLE G)” Ver.1 Rev.
Detailed Diagram of Glass Panel Components 13 11 9 23 28 29 8 Packing List 08 09 11 13 L-shaped strip * U-channel 1 (76”, wall profile) Stationary glass Ø5/16” Wall anchor 1pc 23 1pc 28 1pc 29 14pcs Countersunk screw ST4.2x40 Adjustment spacer U-channel 2 (44”, bottom profile) 14pcs 6pcs 1pc NOTE: Unpack your unit carefully and inspect it. Identify all parts using the detailed diagram and packing list in this manual as a reference.
Style “G”: 6”-34” In-Line Half Wall Stationary Panel Installation NOTE: The Unidoor shower door needs to be installed prior to proceeding with the following Stationary Glass installation instructions. Please see the Single Shower Door installation manual included in the door packaging for complete shower door installation instructions. Before you begin the installation, please recheck your shower opening size. Specific size information can be found on our website at DreamLine.
NOTE: Use parts from “Detailed Diagram of Glass Panel Components” for the Stationary Glass assembly and installation. 2. Measure the actual width and height of your Stationary glass (11). See Fig. 2 for details. H Fig. 2 3. NOTE: You will be doing straight cuts for this stationary panel installation. W *It may be necessary to remove any burrs from the cut end of the U-channels with a metal file before placing the U-channel onto the glass.
H (+) 1" b) Fig. 4 4. Slip the cut U-channel 2 (bottom profile) (29) and U-channel 1 (wall profile) (09) onto the Stationary glass (11) in the shown locations. With the door open, place the Stationary glass on the half wall ledge opposite of door. Adjust the Stationary glass and U-channel 1 (wall profile) against the wall to compensate for any out of plumb conditions ensuring that the Stationary glass is level vertically and U-channel 1 is flush with the wall.
5. While securely holding the Stationary glass (11), close the Glass Door and align the Stationary glass to it. Use the door mark on the ledge as a reference to ensure that the Door is perpendicular to the wall. 2 1 outside Stationary glass Door inside 1/8"-3/16" NOTE: The top of the Stationary glass must be leveled with the Glass door. By traversing across the top of both the Stationary glass and door, height differences can be measured.
6. Remove the U-Channel 2 (bottom profile) (29) and U-channel 1 (wall profile) (09) from the Stationary glass (11). Carefully set the Stationary glass aside. See Fig. 8 for details. U-channel 1 U-channel 2 Fig. 8 7. Place the c u t U-Channel 2 (bottom profile) (29) onto the ledge in line with the inside mark. Mark the drill holes on the ledge through the predrilled holes in the U-Channel 2 and drill the holes using Ø5/16” drill bit. Insert the Ø5/16” Wall anchors (13).
Fig. 10 8. Cut the U-channel 1 (wall profile) (09) at the top mark that was made in step #5. Place the U-Channel 1 (wall profile) on the U-Channel 2 (bottom profile) (29) and align vertically with the inside wall mark. Mark the drill holes on the wall through the predrilled holes in the U-Channel 1. 1 U-Channel 1 2 U-Channel 2 3 Now drill holes in the wall using Ø5/16 drill bit and insert the Ø5/16” Wall anchors (13). 4 Ø5/16” 5 See Fig. 11 for details. Fig. 11 “UNIDOOR (STYLE G)” Ver.1 Rev.
9. Apply waterproof silicone along the bottom surface and around the holes of the UChannel 1 (wall profile) (09). Fasten the U-Channel 1 to the wall with the Countersunk screw ST4.2x40 (23). Insert the provided Adjustment Spacers (28) into U-Channel 2 (bottom profile) (29) for minor adjustments if necessary. Apply Waterproof silicone into the groove of both U-Channels. NOTE: The surface needs to be clean and free of debris before applying silicone. 1 3 waterproof silicone 2 4 5 See Fig.
10. Slide the Stationary glass (11) into the groove of both U-Channels. Apply a bead of silicone on the open end of the U-Channel, and its connection. Ensure that the silicone applied to the open end is flat and smooth so that it will not interfere with the installation of the Lshaped strip*(08) in step #12. NOTE: If you have difficulty sliding the Stationary glass into the U-Channels, you can slightly tap on the Stationary glass with a rubber mallet and a piece of wood.
11. Apply a good quality mildew resistant waterproof silicone along the connection of both U-Channels to the wall and ledge on the inside of shower. See Fig. 16 for details. waterproof silicone ATTENTION: Prior to the next step, please be sure the part of the wall and glass edge for installation of the L-shaped strip*(08) is clean, dry and free from soap, oil and any construction debris. 12.
Product Maintenance BASES and BACKWALLS: To ensure long lasting life for your acrylic back walls: wipe them off after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal brushes or scrapers that could scratch or dull the surface. GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use with a soft cloth.
TEL: 866-731-2244 FAX: 866-857-3638 DREAMLINE.COM For more information on DreamLine® Shower Doors and Enclosures please visit DreamLine.com “UNIDOOR (STYLE G)” Ver.1 Rev.