Manual

13PRISM PLUS with Buttress Shower enclosure manual Ver 1 10/2018

NOTE: It is advisable to allow the silicone holding the

Hinge Panel Glass (#02) in the U-Channel (72”) (#01) to

cure before hanging the Door Glass (#06).

Fig 8b

13/16” shims

NOTE: These adjustable

hinges are factory set to

overclose. See Page 21 for

instructions regarding the

adjustment features of these

hinges.

DO NOT install the Handle onto the door glass until instructed.

DO NOT lift the door glass using the Handle. This could result in

damage to the glass and /or serious personal injury. Always use an

assistant or a professional grade glass suction cup when handling

heavy glass.

Fig 9

TIP: Use a 13/16” shim beneath the door glass

to help align the Door Glass (#06) with the

hinges. This will protect the threshold and the

bottom of the door glass from damage and allow

proper spacing for the Sweep Vinyl (#08).

(Fig 8b)

Leave the shims in place beneath

the door glass while the silicone

cures and while you dry-fit and

install the buttress panel glass.

Install the hinges flush

with the edge of the

Hinge Panel Glass

hinge panel

outside

2mm hinge

gasket

9. Attach the 130º Glass-to-Glass Adj Hinge (#12) onto the Hinge Panel Glass (#02) with the bolts

facing inside the shower and flush with the edge of the glass. Use one 2mm hinge gasket per side.

Tighten the hinge bolts evenly and snap in the decorative bolt caps. (Fig 9)