Manual

21PRISM PLUS with Buttress Shower enclosure manual Ver 1 10/2018

• The overclose setting requires strike vinyl for the door to close against and seal.

• Use a soft cloth to clean the hinge surfaces. Do not use abrasives or acidic liquids as this will damage the finish.

• Be careful not to scratch the finished surfaces of the hinge during installation.

Safe Use & Daily Maintenance

Figure 1 Figure 2 Figure 3

Outside

Inside

Door

Hinge Panel

as viewed from

inside the shower

HG-PRS30A Adjustable Hinge Manual

Installation & Adjustment

Make sure the door glass

is plumb and the edge of

the hinge is installed flush

with the glass edge. Tighten

the faceplate screws.

(Figure 1)

2. The hinges are set to over-

close at 130°degrees. You can

change this angle by using the

adjustment screws on the

hinge plate.

(Figure 2)

3. Use the supplied Allen Key

to loosen the adjustment

screws on the hinge plate,

adjust the door to the

desired angle then tighten

the adjustment screws.

(Figure 3)