Manual

PRISM PLUS with Buttress Shower enclosure manual Ver 1 10/2018

IMPORTANT STEPS TO FOLLOW:

◻ Use 100% silicone caulk - a quick-drying or fast-curing silicone is

recommended for the installation of hinge panel glass into the U-Channel

◻ Apply enough silicone into the U-Channels to secure the panel glass

◻ Fully tighten the L-Bars™ on the Hinge Panel Glass and the Buttress

Return Panel

◻ DO NOT remove the spacers or shims from beneath the door

glass for at least 24 hours to allow the silicone to fully cure in the

U-Channel holding the hinge panel glass

◻ The hinge panel glass for this model should not be adjusted

more than 1/4” within the U-Channel for an out-of-plumb wall

condition

◻ Refer to the product installation manual for more details

Hours

The hinge panel glass must be properly installed and secured to support the

weight of the door glass. Failure to follow these steps may result in the hinge

panel glass pulling out of the U-Channel.

100% Silicone

NOTE: Leave spacers or shims in place beneath the door glass for 24 hours.

If time allows, delay installing the door glass onto the hinge panel glass for

24 hours until the silicone securing the hinge panel glass has fully cured.