Installation Guide

UNIDOOR PLUS (STYLE L) manual Ver 1 Rev 6 10/2016

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with your packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the needed parts are included in the package by checking off the components on

the “Detailed Diagram of Shower Door Components”. If the unit has been damaged, has a

finishing defect, or has missing parts, please contact our customer support department within

3 business days of the delivery date. Please note that DreamLine

will not replace any

damaged products or missing parts free of charge after 3 business days or if the product has

been installed. Feel free to contact DreamLine

if you have any questions, and please provide an

order number, job name or other proof of purchase to help us identify your original order.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine is

not responsible for code compliance standards for your project and will not accept any

returns.

3. If this unit is going to be installed in new construction, please install all of the required plumbing

and drainage before installing the shower. Use a competent and licensed (if required by local

code) plumber for all plumbing installation.

4. Prior to the installation, please ensure that the installation surface is level and solid and will be

able to support the total weight of the unit. Also make sure that the walls are plumb. Depending

on the type of unit you are installing, some adjustments in leveling may be possible. However,

irregular installation, surface level or out of square conditions can result in serious problems for

your installation. Please note that some adjustments and drilling may be necessary. Please protect

all primary surfaces of the product during installation. Never set your glass down directly onto a

tile floor. Always use a piece of wood or cardboard to protect the bottom edge and corners of the

glass.

5. Note: The installation of this unit requires that you drill down into the threshold.

6. This unit must be installed upon a finished threshold and against finished walls.

7. This model requires a minimum 5/8” of flat threshold space for installation.

8. This model has 1/2” of adjustment within the u-channel on the stationary panel side for

out-of-plumb wall conditions and overall width within the model size. Confirm the finished

opening conditions before proceeding with the installation.

9. Stationary panel sizes of 30” and 34” are nominal dimensions referring to the overall size of the panel

once installed and not the actual glass size.

10. The safety of any installation is the responsibility of the installer.

Professional installation recommended.

NOTE: This model is reversible for left or right hand installation. This manual will show the right

side return panel installation. For a left side return panel installation, simply begin on the opposite

wall and reverse the orientation of the parts as necessary.