Installation Guide

“UNIDOOR PLUS (STYLE L)” Ver.1 Rev 4 06/2016
8
3. Slip the cut U-channel 2 (44”, bottom profile) (29)
and uncut U-channel 1 (76”, wall profile) (09) onto
the Stationary glass (11) in the shown locations.
With the door open place the Stationary glass on
threshold adjacent to door and in line with wall mark.
Adjust the Stationary glass and U-channel 1 (wall
profile) against the wall to compensate for any out
of plumb conditions ensuring that the Stationary
glass is level vertically and U-channel 1 is flush with
the wall.
Mark the U-channel 2 (bottom profile) end
opposite of the wall at the exposed vertical glass
edge.
Remove the U-channel 2 (bottom profile). Leave
the U-channel 1 (wall profile) on the Stationary
glass. Set the Stationary glass aside.
Cut the U-channel 2 (bottom profile) to the mark (-)
3/8” for Anti-Water strip (Enclosure) (20).
Slip the U-channel 2 (bottom profile) back onto
the Stationary glass.
See Fig. 4 for details.
4. Press the Anti-Water strip (enclosure) (20) onto the
vertical edge of the Stationary glass (11).
Carefully butt the Stationary glass up against the
wall vertically according to the outside enclosure
mark that was made in step #1. Intermittently use a
level throughout these steps to ensure that this glass
enclosure is leveled properly.
While securely holding the Stationary glass, close
the Glass Door and align the Stationary glass to it.
If needed, adjust the position of the Stationary glass
to make sure the Anti-Water strip makes tight
contact to the Glass Door from top to bottom.
Outline the position of the Stationary glass along
the inside edge of both U-channels on the wall and
threshold base.
Mark the U-channel 1 (wall profile) at the top
horizontal glass edge.
See Fig. 5 for details.
wall
inside
Stationary
glass
U-channel 2
U-channel 1
inside
U-channel 2
mark - 3/8"
Fig. 4
1
3
5
2
4
6
1
3
2
5
W1
4
inside
wall
inside
wall
outside
inside
inside
wall
30 1/2"
outside
Fig. 5
1
3
5
2
4
6