Manual

© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
24
UNIDOOR-X (STYLE M) manual Ver 2 Rev 1 02/2019
©2019 DreamLine. All Rights Reserved
2
4
Door
1”
1
2
3
4
5
6
7
8
Around Bottom sweep
measure
measure
1
Handle side of door
Fig 23
Fig 22
3
Panel
22. Measure the bottom of the Door Glass (#01) from
side to side to determine the actual width of the door.
Cut the Bottom Sweep Vinyl (#07) to the size of your
measurement and notch 3/8” of the inner side of the
Bottom Sweep Vinyl (#07) as shown in Fig 22.2.
Press the Bottom Sweep Vinyl (#07) onto the bottom
edge of the Glass Door (#01).
NOTE: Make sure the Bottom Sweep Vinyl (#07) is flush
to the vertical edge of the handle side of the Door Glass
(#01). (Fig 22)
23. To install the Hinge-Side Vinyl Seal (#33), take three measurements :
• from the top edge of the Door Glass (#01) to the top of the center portion of the top Hinge (#06)
(see Fig 23.1 for an example to use for taking all three measurements)
• from the bottom of the center portion of the top Hinge to the top of the center portion of the
bottom Hinge (#05)
• from the bottom of the center portion of the bottom Hinge (#05) to the threshold
Cut the Hinge-Side Vinyl Seal (#33) according to these measurements. Notch the cut strips to slide
them into the hinges and around the installed Bottom Sweep Vinyl (#07) to cover the space
between both glass panels. Open the door and press the cut strips onto the vertical edge of the
Door Glass (#01) so they will overlap the panel glass. (Fig 23)