Manual

Other Configurations

Q-WALL Installation Manual Ver 2 112019 24

Shower Height

(Small alcove)

Corner Shower

Corner

1) Measure the opening

2) Transfer measurements to both side panels

and cut them to size, accounting for overlap and

alignment of brick pattern in corners (see p. 8

bottom)

3) Install one Q-Wall Side Panel on either wall.

4) Install one J-Strip against the face of the

panel just installed (to receive the 2nd panel)

5) Install the second Q-Wall and slide it into the

J-Strip.

6) Install J-Strips on the outside edges of both

Q-Wall Side Panels

Shower Height (Small Alcove)

1) Measure the opening

2) Transfer measurements to side panel (to be

used against back wall)

3) Install Q-Wall Side Panel at rear of shower

4) Install J-Strips on back corners

5) Measure side shower walls

6) Mark and cut Q-Wall Side Panels including

holes for fixtures, accounting for overlap and

alignment of brick pattern in corners

pattern (See p. 8 bottom)

7) Install Q-Wall Side Panels on both walls

8) Install J-Strips on the outside edges of both

Q-Wall Side Panels

The rear J-Strip holds

the overlapping Q-Wall

Side Panel. Either panel

can overlap the other.

The techniques to install the Q-Wall Back Panels, Q-Wall Side Panels and J-Strips are the same for all

congurations. The dierence is in the amount and types of Q-Wall Panels and J-Strips and the installation order.

The Small Shower Height and the corner congurations do not have overlapping Q-Wall Back Panels. The Small

Shower Height conguration uses 3 Q-Wall Side Panels and 4 J-Strips. The Corner conguration uses 2 Q-Wall

Side Panels and 3 J-Strips. See the diagrams below for the installation sequence and correct placement of parts.