Installation Guide

INFINITY-Z manual Ver 4 Rev 4 09/2016
11
14. Install the Handle (06) to the Door Glass (04).
Press the anti-water strips (07) onto the vertical edges of the
Stationary glass (05) and both vertical edges of the Door Glass
(04). Insert the Seal gasket (15) into the Glass profile (01)
starting from the bottom. (Fig. 14.3)
See Fig. 14 for details.
15. Perform the final adjustments of the assembled unit in the Wall
profiles (02) making sure that the bottom rail is tight to the threshold.
Drill the holes in the center of the Wall Profile (02) into the Glass
profile (01) using an Ø 1/8” drill bit.
ATTENTION:
Do not drill the profiles throughout, only through the first layer of
the wall and glass profiles.
Secure the Wall Profile (02) to the Glass profile (01) using the Round
head screws ST4.2×10 (11) and raised white washers.
Cover the exposed screw heads with the Decorative covers (13).
See Fig. 15 for details.
Fig. 15
2
1
3
Fig. 14
TIP: The longer anti-water strips (07) attach to the
edges of the Door Glass (04) and the shorter strip
attaches to the edge of the Stationary glass (05).
outside