Installation Guide

INFINITY-Z manual Ver 4 Rev 4 09/2016
5
Shower Door Installation
1. Measure the distance between the two finished walls
at the top (at model height: 58” or 72”), middle and
bottom. The wall profiles will adjust for out-of-
plumb conditions, so use the smallest
measurement as the “finished opening” dimension
to determine the finished cut length in step#2.
See Fig. 1 for details.
2. Subtract 3-3/8” from your finished opening (W) to
determine the finished cut length for the Top and
bottom guide rails (03). Cut the Top and
bottom guide rails (03) to the finished cut
length “D”. Cut from the door end, (which is the
end farthest from the glass holder hole) and cut
each rail to the same length from the same end.
See Fig. 2 & Fig. 3 for details.
Model Size
Precut
Rail Length
48” (for shower)
44-5/8”
60” (for shower)
56-5/8”
60” (for tub)
56-5/8”
W
Top
Middle
Bottom
Fig. 1
NOTE: The Top and bottom Guide Rails (03)
are shorter than the model size by design. They
have been precut for your model width and are
made to fit between the wall profiles, (not wall
to wall). See the table below:
FINISHED OPENING (W) - 3-3/8”= FINISHED CUT LENGTH
“D”
TIP: For easier installation into the opening cut off an extra 1/4”:
FINISHED OPENING (W) - 3-5/8”= FINISHED CUT LENGTH “D”
Fig. 2
Fig. 3