Installation Guide

INFINITY-Z manual Ver 4 Rev 4 09/2016

3. After the Top and bottom guide rails (03) have been cut, you

will need to re-install the roller stopper on each Top and

bottom guide rails (03) on the end that has been cut off

(the door end).

Remove the existing stopper. Mark the drilling hole at a

distance of 3-1/8” from the cut end of the Top and bottom

Guide rail (03).

Drill a new hole using an Ø1/8” drill bit; then re-secure the

stopper with the screw.

ATTENTION:

Do not drill the Guide rail throughout, only through the

first layer.

See Fig. 4 for details (bottom guide rail shown)

4. Secure the bottom Top and bottom guide rails (03) to the

Glass profiles (01) with the Round head screws ST4.2x25 (10).

See Fig. 5 for details.

Ø 1/8”

3 1/8”

TIP: For ease of assembly, add some liquid soap,

wax or lubricant to the screws prior to attaching

the glass profiles to the guide rails. Use a low

setting on your power drill to prevent stripping the

screws.

Fig. 4

Fig. 5