Installation Guide

INFINITY-Z manual Ver 4 Rev 4 09/2016

8. Slide the Wall profiles (02) all the way onto the Glass

profiles (01) on both sides. Make sure the flange of the wall

profile faces inside the shower.

See Fig. 8 for details.

9. Move the assembled frame into the designated

position on the shower base*, bathtub or threshold

(depending on your installation), and push the Wall

Profiles (02) tight to the walls to compensate for any

out-of-plumb conditions.

Push the bottom rail down tight to the threshold and

adjust the frame to a vertical position. Confirm with a

level before marking the holes for drilling.

See Fig. 9 for details.

Fig. 9

Fig. 8

inside

*NOTE: At this step you can reverse the

handing of the installation by flipping the

assembly top to bottom so that the panel is on

the right side.