Installation Guide

INFINITY-Z manual Ver 4 Rev 4 09/2016

10. Use a helper to hold the assembly in position and

mark the drill holes on the wall through the holes on

the flange of the Wall Profiles (2).

Gently set the assembled unit aside; drill the holes

using a Ø 5/16” drill bit and insert the Wall anchors

(14).

Apply silicone along the wall profile and around the

holes on the wall. Also apply silicone caulk under the

bottom Guide rail (03). Place the entire shower

assembly back into the designated position and

secure it to the walls using the Truss head screws

ST4.2×40 (09).

See Fig. 10 for details.

11. Attach the Towel bar (18) to the outside of

the Stationary glass (05).

NOTE: Towel bar must be installed on the

outside of the stationary glass.

See Fig. 11 for details.

Fig. 11

Ø 5/16”

Fig. 10

outside