Installation Guide

16ENCORE / BRAVO Manual Ver 1 Rev 4 11/2016
Fig 15
Fig 16
3
outside
of
shower
Cover plate /
Mounting bolt
Loosen /
tighten
Adjustment
Bolt
cover plate
adjustment bolt
mounting bolt
Use the adjustment bolt on the roller
assemblies to adjust the door glass
15. Install both the inside and outside Towel bars (#08) using
all provided gaskets as shown. Cover the bolt with the decora-
tive cap.
See Fig 16 for details
14. To compensate for minor out-of-plumb conditions
(up to 3/8”): After both doors are installed, use the Allen
Wrench (#14) to make minor adjustments with the Roller
Assemblies (#06) as necessary.
Remove the cover plate, then loosen the mounting bolt on
the roller. Rotate the adjustment bolt on the bottom of the
wheel assembly to tilt the door glass to the desired
position. Re-tighten the mounting bolt and replace the
cover plate.
See Fig 15 for details