Installation Guide

7ENCORE / BRAVO Manual Ver 1 Rev 4 11/2016
Fig 2b
FOR EXAMPLE: If the finished opening
W = 59”, then 59“- 3/4” = 58-1/4”
finished cut length “L” will be 58-1/4“.
(The Bottom rail length for the
60”model = 59-3/8“ - 58-1/4” = 1-1/8”
1-1/8” divided by 2 = 9/16”
Cut 9/16” off from each end to a
finished cut length of 58-1/4”).
Note that this is only an example
and the actual cut-off amount will
vary based on the actual finished
opening dimension.
Model Size
Precut Boom Rail Length
60” x 76”
59-3/8” (1508mm)
48” x 76”
47-3/8” (1203mm)
60” x 58”
59-3/8” (1508mm)
54” x 76”
53-3/8” (1356mm)
Table A
Note: The Bottom guide rail (#15)
needs to be shorter than the Upper
guide rail (#02) because it fits between
the wall profiles, while the upper guide
rail fits wall-to-wall.
W-3/4” (18mm)
EQ
EQ
L
3/8” (9mm)
3/8” (9mm)
W= finished opening width
center bottom guide
W (finished opening) - 3/4”
= L (finished cut length)
Bottom Guide Rail (#15)
W-1/16” (1.5mm)
L
Upper Guide Rail (#02)
Fig 2a
Finished cut length L
W (finished opening) - 1/16”
= L (finished cut length)
2. Using a miter saw or hacksaw, cut the Upper Guide Rail (#02) 1/16” shorter than the top
dimension W from step #1. (W - 1/16“ = finished cut length L) ( see Fig 2a)
The Bottom Guide Rail (#15) needs to be cut equally from both ends to keep the center guide
holes centered. (The Bottom Guide Rail (#15) has been precut for the model size. See Table A).
Using a miter saw or hack saw, cut the Bottom Guide Rail (#15) 3/4” shorter than the bottom
dimension W from step #1. (W - 3/4“ = finished cut length L) (see Fig 2b)
See Fig 2a & 2b for details