Installation Guide

“UNIDOOR (STYLE B & C)” Ver.2 Rev.9 06/2016

5. While securely holding the Stationary glass (11) close

the Glass Door and align the Stationary glass to it.

Use the door mark that was made in step #1 on the

threshold as a reference to ensure that the Door is

perpendicular to the wall.

If needed, adjust the position of the Stationary glass

so that the Anti-Water strip (inline panel) (19)

makes tight contact to the Glass Door from top to

bottom.

NOTE: The top of the Stationary glass must be

leveled with the Glass door.

Draw a line along the inner edge of the Wall profile

(09) on the wall.

Mark the drilling hole of the Bottom bracket (18) on

the shower base or threshold through the oval

notched hole.

See Fig. 5 for details.

6. Detach the Wall profile (09) from the Stationary

glass (11) and Glass profile (10) assembly.

Replace the Wall profile to the outlined position that

was made in step #5 and mark the drill holes on the

wall through the predrilled holes in the Wall profile.

Now drill holes in the wall using Ø 5/16” drill bit and

insert the Wall anchors (13).

Apply silicone along the Wall profile and around the

holes. Fasten the Wall profile to the wall with the Big

flat head Screw ST4.2×40 (15).

See Fig. 6 for details.

Ø5/16”

outside

inside

outside

inside

Door

Align stationary glass

and glass door

inside

1/16"-1/8"

Stationary

glass

Fig. 5

inside

Fig. 6

Ø5/16”