Installation Guide

“UNIDOOR (STYLE B & C)” Ver.2 Rev.9 06/2016

Style “B”: Support bar Assembly and Installation

NOTE: Use parts from Diagram “A” for the Support Bar assembly and installation.

10. Locate the Support bar (12).

Adjust the bar to a proper position on the glass and

the wall. Level it horizontally. Hold it firmly and

outline the bracket’s position on the wall. Remove the

Support bar and detach the wall bracket from it.

Place the wall bracket against its outlined position on

the wall and mark the drilling hole.

Drill the hole using Ø 5/16” drill bit, insert the Wall

anchor (13) and fasten the wall bracket to the wall

with the Big flat head screws ST4.2×40 (15). Attach

the Support bar to the wall as shown on Fig 11.6 and

tighten the *set screws and the glass holding screw to

secure the glass.

*NOTE: Make sure that the rubber gasket is in

place on the glass on the side opposite of the set

screw before securing the Support bar.

See Fig. 11 for details

Fig. 11

Ø5/16”