Installation Guide

INLINE PANEL - Style C shower panel manual Ver 1 01/2018

Use Caution not to pull the Glass Profile (#10) off of the Panel Glass (#11).

Fig 5

Fig 6

inside

panel glass

Door

1/16"-1/8"

inside

align the panel glass

with the door glass

Ø5/16"

(8mm)

inside

1 2 3 4 5

3 4

OOR

ANEL

The two-piece wall profile

system (consisting of the glass

profiles and wall profiles) will

allow for overall width and/or

out-of-plumb adjustment

within the model size.

See page 6 for details.

5. Close the Door and align the Panel Glass (#11) with the

Door Glass. Use the reference mark on the threshold (from

Step #1 ) to confirm that the Door is perpendicular to the

wall. If needed, adjust the position of the Panel Glass

(#11) so that the Anti-Water Strip (inline) (#19) makes

contact with the Door Glass from top to bottom and

creates a seal.

◾Mark the wall along the inner edge of the Wall Profile

(#09).

◾Mark the drilling hole onto the threshold through the

hole in the Bottom Bracket (#18). (Fig. 5)

6. Remove the Wall Profile (#09) from the Glass Profile (#10)/Panel Glass (#11) assembly.

Place the Wall Profile (#09) back onto the outlined position on the wall and mark the holes

for drilling through the predrilled holes in the Wall Profile (#09).

Drill the holes in the wall using a Ø5/16” drill bit and insert the Wall Anchors (#13).

Apply silicone along the back of the Wall Profile (#09) and around the holes on the wall.

Fasten the Wall Profile (#09) to the wall with the Truss Head Screw ST4.2×40 (#15). (Fig 6)