Installation Guide

“UNIDOOR” Single Shower Door Ver.2 Rev.2 06/2016
17
5. Mount the Handle (02) to the Door Glass (01).
See Fig. 6 for details.
6. Measure the bottom of the Door Glass
(01) from end to end to determine the
actual width of the door. Cut the
Bottom anti-water strip (07) to the
size of your measurement and notch
3/8” of the inner side of the Bottom
anti-water strip as shown.
Press the Bottom Anti-water strip (07)
onto the bottom edge of the Door Glass
(01).
NOTICE:
Make sure the Bottom anti-water strip
is flush to the vertical edge of the
Handle side of the Door Glass.
See Fig. 7 for details.
Fig. 6
2
1
3
inside
outside
inside
outside
4
inside
outside
inside
outside
Handle side
strip end
3/8"
Fig. 7
NOTE: DO NOT attach the handle to the
door glass until instructed to do so.
DO NOT use the handle to lift the glass
during installation. This may result in damage
to the glass and/or serious injury. Always use
an assistant or a professional grade glass
suction cup when handling the door glass.