Installation Guide

“UNIDOOR” Single Shower Door Ver.2 Rev.2 06/2016

7. Get three measurements:

 from the top edge of the Door Glass (01) to the

upper body of the top Hinge (05) (+) 7/8”

 from the lower body of the upper Hinge to the

upper body of the bottom Hinge (+) 1-3/4”

 from the lower body of the bottom Hinge to top

of the installed Bottom anti-water strip (07)

(+) 1-7/8”

Cut the Side strip (06) according to the

measurements.

Notch the cut strips to be able to slide them into

the Hinge and around the sweep vinyl to cover the

space to the wall.

Press the cut strips onto the vertical edge of the

Door Glass.

See Fig. 8 for details

ATTENTION;

Prior to the next step, please be sure that the section of the

wall where you need to attach the L shaped strip (08) is clean,

dry and free from soap, oil and any construction debris.

8. With the door closed place the *L-shaped strip (08) on the door

edge and mark its location on the wall.

Please note that the corner of the L-shaped strip (08) should

face inward.

With the door opened, remove the tape backing from the adhesive

strip and firmly press the L shaped strip (08) to the wall.

See Fig. 9 and Fig. 10 for details.

*NOTE:

The above procedure for installing the L-shaped strip (08) is for

the Unidoor Style A single shower door installation only. If

installing another model with additional panel glass, please

refer to the separate glass installation manual located in the

glass packaging for model specific instructions. The vinyl seals

that apply to the panel glass are packaged with the panel glass.

1 2

Into the hinge

7/8"

Into the hinge

Around sweep vinyl

7/8"

Fig. 9

inside

Fig. 8