Installation Guide

“UNIDOOR” Single Shower Door Ver.2 Rev.2 06/2016

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with your packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the needed parts are included in the package by checking off the components

on the “Detailed Diagram of Shower Door Components”. If the unit has been damaged, has a

finishing defect, or has missing parts, please contact our customer support department within

3 business days of the delivery date. Please note that DreamLine

will not replace any

damaged products or missing parts free of charge after 3 business days or if the product

has been installed. Please contact DreamLine

if you have any questions and please provide an

order number, job name or other proof of purchase to help identify the original order.

2. Please note that you should consult your local building codes with questions about

installation compliance standards. Building and plumbing codes may vary by location, and

DreamLine

is not responsible for code compliance standards for your project and will not

accept any returns.

3. If this unit is going to be installed in a new construction, install all of the required plumbing and

drainage before installing the shower. Use a competent and licensed (if required by local code)

plumber for all plumbing installation.

4. Please make sure that prior to beginning the installation, the surfaces are leveled and solid and

will be able to support the total weight of the unit. Also make sure the walls are at right angles.

Irregular installation surface level, radius corners or improper angle of side walls will result in

serious problems for your installation. Please note that some adjustments and drilling may be

necessary during the installation process.

5. Please protect all primary surfaces of the product during installation. Never set your glass down

directly onto a tile floor. Leave corner protectors in place until necessary to remove them. Always

use a piece of wood or cardboard to protect the bottom edge and corners of the glass prior to

and during installation.

6. This unit must be installed upon a finished threshold and against finished walls.

7. This door is extremely heavy and the hinges on this door must be attached to the studs or

to preinstalled 2” × 6” wood reinforcement behind the wall. See pages 8, 9 & 10 for details.

8. The single Unidoor installation does NOT have any adjustment for out-of-plumb conditions.

Please verify that your walls are plumb before proceeding with the installation.

9. Professional installation is recommended for this heavy glass frameless shower door.

NOTE: DO NOT attach the handle to the door glass until instructed to do so. DO NOT use the

handle to lift the glass during installation. This may result in damage to the glass and/or serious injury.

Always use an assistant and/or a professional grade glass suction cup when handling heavy glass

panels.