User Guide

Table Of Contents

“AQUA SERIES TUB EX/RT”, PANEL Rev.1 Ver.1 06/2014

Configuration 3: 30” Return Panel Installation

NOTE: The following installation instructions apply

to all of the Aqua series tub doors. Please install

whichever Aqua model you purchased prior to

proceeding with the following Return Glass

installation instructions. Please see the Shower / Tub

Door Installation manual included in the door

packaging for complete tub door installation

instructions.

NOTE: The “Standard” Aqua Hinged Tub Door is

the example shown throughout this installation

manual.

NOTE: Use parts from Diagram “B” for the glass

panel assembly and installation.

7. Slip the U-channel 2 (bottom profile) (02) and U-

channel 1 (wall profile) (01) onto the Return panel

glass (17) in the shown locations.

With the door open, place the Return panel glass

onto the middle of the tub ledge adjacent to the door

ensuring that the U-channel 1 (wall profile) (01) is

flush with the wall.

Adjust the Return panel glass vertically using a level.

Outline the position of the Return panel glass along

the inside edge of both U-channels on the wall and

tub ledge.

Remove the U-channel 1 (wall profile) (01) and U-

channel 2 (bottom profile) (02) from the Return

panel glass and carefully set the Return glass aside.

See Fig. 10 for details.

U-channel 2

U-channel 1

wall

Return

glass

inside

inside inside

U-channel 2

U-channel 1

Fig. 10