Installation Guide

Installation steps

ELEGANCE / ELEGANCE-LS / ATLAS (Style A) shower door manual Ver 1 01/2018

NOTE: If this door is to be part of an

enclosure model, refer to the model size

table in the enclosure panel glass manual

for the correct placement of the door glass

to match the enclosure size.

**When installing into a stud (recommended but not required) drill Ø1/4” holes up

to the stud and drill Ø1/8” pilot holes into the stud and do not use the wall anchors.

NOTE: The Wall Profile for Pivot Side (#01) has an

additional pair of holes at each end and is milled out

to accept the Pivot Retainers (#08) (Fig 1.1). These

extra holes are not present in the Wall Profile (#05)

that is used for the strike side (or panel side for

models with an additional panel).

Fig 1

Ø5/16”

2**

3**

The Elegance-LS / Atlas Left-Swing

door installation is shown as an

example throughout this manual.

1. Position the Wall Profile for Pivot Side (#01)

onto the threshold and against the desired

hinge-side wall and adjust to plumb.

Mark all eight (8) drill holes on the wall through

the predrilled holes in the Wall Profile for Pivot

Side (#01).

Next, drill the holes using a Ø5/16” drill bit and

insert the Wall Anchors (#12). (Fig 1)