Installation Guide

ELEGANCE / ELEGANCE-LS / ATLAS (Style A) shower door manual Ver 1 01/2018

NOTE: Attach the hinges to the Glass Profile for

Pivot Side (#02) as shown in Fig 4.

The Back Plate (K) of the Pivot Assembly (#07)

must face inside of the shower.

(see the diagram parts list for hinge part details)

NOTE: The Glass Profile for Pivot Side (#02)

is shorter and has an additional pair of holes

at each end for the Pivot Assembly (#07). These extra

holes are not present in the Glass Profile (#04) that is

used for the strike side/panel side.

Fig 4

Fig 5

1 2 3

outside

Fully tighten this bolt after all

adjustments with the glass profile

have been made

outside

The two piece wall profile system (consisting of the glass profiles and wall profiles)

will allow for overall width and/or out-of-plumb adjustment within the model size.

Inside of

shower

Back Plate (K)

4. Attach the Pivot Assemblies (#07) to the top and

the bottom ends of the Glass Profile for Pivot Side

(#02) with the Flat Head Screws ST4.2×25 (#15)

and M4×16 bolts and washers (#13). (Fig 4)

5. Slide the Glass Profile for Pivot Side (#02) with the attached Pivot Assemblies (#07) into the Wall

Profile for Pivot Side (#01) and secure the top Pivot Retainer (#08) to the top Pivot Assembly (#07)

with the Round Head Socket Bolt M6×12 (#17). (Fig 5)