Installation Guide

ELEGANCE / ELEGANCE-LS / ATLAS (Style A) shower door manual Ver 1 01/2018

NOTE: Sealing the hole in the bottom Pivot Retainer is important.

Screwing the bottom Pivot Retainer to the threshold is optional.

Fig 8

Fig 9

1 2*

*Any width and/or out-of-plumb adjustments using the adjustable wall profile system

must be made prior to screwing the Pivot Assembly (#07) down into the threshold.

When installing the door along with an inline panel or enclosure model, postpone

this step until after alignment with the panel glass.

9. Seal the unused hole in the bottom Pivot Assembly (#07) with the Flat Head Socket Bolt M6×12

(#18) OR attach the Pivot Retainer (#08) to the Shower base or threshold by drilling an Ø1/8” hole and

using a Large Truss Head Screw ST4.2×40 (#16).

Apply silicone sealant over the Screw (#16) or Bolt (#18) to prevent leakage for either method. (Fig 9)

8. Open the Door Glass (#03) to expose the bottom Pivot Retainer (#08). (Fig 8)