Installation Guide

ELEGANCE / ELEGANCE-LS / ATLAS (Style A) shower door manual Ver 1 01/2018

Fig 12

Ø5/16”

Door

”

Adjust the glass profile

within the wall profile

Make sure that the reveal is even along the threshold.

12. Hold the Door Glass (#03) in the closed position, parallel to the threshold.

Adjust the Glass Profile (#04) within the Wall Profile (#05) and adjust the position of the Wall Profile

(#05) on the wall to ensure that the Door Glass (#03) makes tight contact with the flange of the

Anti-Water Strip (#10) from top to bottom. Use a level to ensure that the Door Glass (#03) and the

Wall Profile (#05) are plumb, but make sure that the door glass makes full contact with the strike vinyl.

Draw a line on the wall along the vertical edge of the Wall Profile (#05). Detach the Wall Profile (#05)

from the Glass Profile (#04). Place the Wall Profile (#05) back onto the outlined position on the wall

and mark the holes for drilling through the pre-drilled holes in the Wall Profile (#05).

Drill the holes in the wall using a Ø5/16” drill bit. Insert the Wall Anchors (#12) into the holes. (Fig 12)