Installation Guide

ELEGANCE / ELEGANCE-LS / ATLAS (Style A) shower door manual Ver 1 01/2018

NOTE: Only drill through the first layer of the Glass Profile.

Fig 14

Fig 15

inside

Door

Use caution not to damage the edges of the door glass during adjustments

If necessary, return to

Step# 9 to screw the

bottom pivot retainer

to the threshold.

Otherwise, continue

on to the next step.

Use the Pan Head Screws ST4.2×10 (#14) and Decorative Cover Washers (#09) to secure the Glass

Profiles (#02 and #04) inside of the Wall Profiles (#01 and #05). Cover the exposed screws with the

Decorative Covers (#09).

14. Adjust the overall width of the Door using the Glass Profiles (#02 and #04) on one or both sides of

the opening. Slide the Glass Profiles out of the Wall Profiles up to 1” per side as necessary to maintain a

1/16" - 1/8" reveal between the Door Glass (#03) and the Anti-Water Strip (#10).

(Fig 14.2)

Hold the top of the Door Glass (#03) level and tighten the pivot assembly in place with the Round Head

Socket Bolt M6×12 (#17) (Fig 14.3). Test the operation of the door before proceeding to the next step.

(Fig 14)

15. After final adjustments and leveling of the assembled door and profiles, drill holes into the Glass

Profiles (#02 and #04) through the pre-drilled holes in both Wall Profiles (#01 and #05) using an

Ø1/8” drill bit. (Fig 15)