Installation Guide

INLINE PANEL - Style B shower panel manual Ver 1 01/2018

Double check the alignment and spacing of the panel glass with the

door glass before drilling into the threshold for the bottom bracket.

*NOTE:

◾For installation into an Acrylic Threshold:

drill a Ø1/8”(3mm) hole and use the Pan Head

Screw ST4.2 x 35mm (#16)

◾For installation into a Tile Threshold:

drill a Ø5/16”(8mm) hole, install a Wall Anchor

5/16” (#13) and use the Pan Head Screw

ST4.2 x 35mm (#16)

Fig 7b

Fig 7a

inside

washer

screw

decorative cap

Ø1/8”or

Ø5/16”

outside

inside

outside

**1 2 3 5

inside

7. Drill a hole for the Bottom Bracket (#18) into the threshold at the mark that was made in Step #5.

** Use an Ø1/8” drill bit for installation into an acrylic base OR use a Ø5/16” drill bit and an anchor

for installation into a tile threshold. Use the Pan Head Screw ST4.2x35 (#16) along with a raised white

washer to attach the Bottom Bracket (#18) to the threshold and snap on the Decorative Screw

Cover (#17). (Fig 7a and Fig 7b)