Installation Guide

INLINE PANEL - Style B shower panel manual Ver 1 01/2018

Fig 8

Ø1/8"

1 3

NOTE: Only drill through the first layer of the Glass Profile.

Fig 9a

Fig 9b

If installing a model with a 6” stationary

panel, no additional support is required

and the installation is complete.

(Fig 9b)

If the Stationary Panel width is larger than 6” proceed to:

•Step#11 for the Support Bar installation

•Step#12 for the L-Bar™ installation.

The installation is not complete until the required

Support Bar or L-Bar™ has been installed

inside

Unidoor Style B

w/6” panel shown

washer

screw

decorative cap

9. Apply a good quality mildew-resistant silicone

along the connection of the Wall Profile (#09) to the

wall and the panel glass to the threshold. (Fig 9a)

8. Recheck the alignment and spacing of the Door Glass and Panel Glass (#11) and test the operation

of the Door. After final adjustments of the Panel Glass (#11) drill holes into the Glass Profile (#10)

through the predrilled holes in the Wall Profile (#09) using an Ø1/8” drill bit.

Use the Pan Head Screws ST4.2×10 (#14) and Washers (#17) to attach the Wall Profile (#09) to the

Glass Profile (#10). Cover the exposed screw heads with Decorative Screw Cover (#17). (Fig 8)