Installation Guide

©2018 DreamLine. All Rights Reserved
13
INLINE PANEL - Style B shower panel manual Ver 1 01/2018
1
!
Unidoor Style B
with Support Bar
Fig 10
Support Bar Assembly and Installation
6
2
4
3
5
7
8
Ø5/16"
wall bracket
NOTE: Make sure that the
rubber gasket and/or the rubber
tipped set screw are in place
when securing the Support Bar
to the glass to prevent glass to
metal contact.
10. Attach the Support Bar (#12) to the
Panel Glass as shown.
◾ Adjust the Support Bar (#12) to a proper
position on the
glass and the wall (ideally at a 45° angle)
and level it.
◾ Outline the Wall Bracket’s position on the
wall Fig 10.2.
◾ Remove the Wall Bracket from the Support
Bar (#12).
◾ Place the Wall Bracket against its outlined
position on the wall and mark the hole for
drilling.
◾ Drill the hole using a Ø5/16” drill bit, insert
the Wall Anchor (#13) and fasten the Wall
Bracket to the wall with the Countersunk
Screw ST4.2×40 (#23).
◾ Attach the Support Bar (#12) to the Wall
Bracket as shown on Fig 10.7 and tighten the
set screws and the glass holding screw to
secure the glass. (Fig 10)