Installation Guide

INLINE PANEL - Style B shower panel manual Ver 1 01/2018

NOTE: When marking the L-Bar™ location on the wall, leave the

Decorative Cover attached to allow space to re-attach the

Decorative Cover after installation.

Max 3/16"

(4mm)

Max 3/16"

(4mm)

Fig 11

Fig 12

4 5

Ø5/16”

(8mm)

11. Position the L-Bar™ assembly (#4.3) onto the Panel Glass as shown (Fig 11.1). Be sure the

gaskets are in place to protect the glass. Make it level and mark the position on the wall.

Remove the Decorative Cover (#4.4) and Wall Plate (#4.6) from the L-Bar™. Position the Wall Plate

(#4.6) on the marks on the wall and adjust for level. Mark the holes for drilling through the wider,

untapped holes (Fig 11.3). Drill two Ø5/16”(8mm) holes and insert the Ø5/16” Wall Anchors (#4.5).

(Fig 11)

12. Attach the Wall Plate (#4.6) to the wall using the ST4.2 x 40 Truss Head Screws (#4.7).

Re-attach the L-Bar™ (#4.3) to the Wall Plate (#4.6) using the Flat Head Screw M5x14 (#4.8).

Adjust the angle of the L-Bar™ if necessary by using the Wall Plate Adjustment Set Screws (#4.9).

(Fig 12)