Installation Guide

ENIGMA-X Enclosure manual Ver 7 Rev 1.1 02/2018

Fig 9b

Fig 9a

Glass Connector (#28)

1 2 3

Glass Bracket adjustment

rotate disk(s) to level rail

Lower guide rail Raise guide rail

Glass Bracket adjustments

not used in this

configuration

sleeve

rotate disk to level rail

9. Place the Stationary Glass (#02) with the Upper Guide Rail (#03) onto the threshold and position it

against the wall. Fasten the Upper Guide Rail (#03) to the Return Panel (#27) using the Glass

Connector (#28). (Fig 9a)

Tighten the set screws to secure the guide rail bracket sleeve to the Glass Connector (#28). (Fig 9a)

Make sure the Stationary Glass (#02) and the Upper Guide Rail (#03) are level. If a horizontal

adjustment is required; loosen, rotate and re-tighten the disks on the Glass Brackets (#07) and/or the

Glass Connector (#28). (Fig 9b)

Note: When installing the 72” model, proceed to Step #10.

When installing the 48”or 60” model, skip to Step #13 to continue

with the installation.