Installation Guide

ENIGMA-X Enclosure manual Ver 7 Rev 1.1 02/2018

inside

Fig 13b

Fig 13a

Fig 12

rotate disk(s) to level rail

for 72” model

12. If installing the 72” model:

Unscrew the disk from the Small Stationary Glass Bracket (#21) and loosen the set screw that secures

the bracket to the guide rail. If necessary, slide the Door Stopper (#01) away from the area so that it will

not interfere with the placement of the Small Stationary Glass (#23). (Fig 12.2)

Position the Small Stationary Glass (#23) onto the threshold and carefully butt it up against the installed

Return Panel Glass (#27). Align the Small Stationary Glass Bracket (#21) with the hole in the Small

Stationary Glass (#23). Re-attach the outer disk and secure the Small Stationary Glass Bracket (#21) to

the Upper Guide Rail for 72” (#24). (Fig 12)

13. Once the Upper Guide Rail (#03) is level, mark the position of the Guide Rail Bracket (#08) and

the Wall Bracket (#19) on the wall. (Fig 13a)

*NOTE: If installing the 72” model, also mark the position of the Wall Bracket (#19) on the threshold

for the Small Stationary Panel Glass (#23). (Fig 13b.3*)