Installation Guide

ENIGMA-X Enclosure manual Ver 7 Rev 1.1 02/2018

(Right hand door installation shown as an example)

Fig 34

72” model

door

small panel

Fig 33

wall

door

outside

door

inline panel

inside

add threadlock to

the safety set screw

and wheel bolt

48”or 60”

model

Note: Use a razor knife to trim the Anti-Water Strip (#14) at the top to avoid

interfering with the Roller Guards (#29) and at the bottom where the door

meets the Bumper (#30).

Note: The Safety set screw on both wheels MUST BE RE-TIGHTENED

after installation to prevent the large bolt from coming loose. Apply thread

lock during installation. (See Fig 33 and Page 33 for more details)

31. Press the Anti-Water Strip (#14) onto the vertical edge of the Stationary Glass (#02) and the

Door Glass (#05). For 48” and 60“ models, press the Bumper Strip (#13) onto the vertical edge of the

Door Glass (#05). (Fig 34.2)

For the 72” model: Attach Anti-Water Strip (#14) to the edge of the Small Stationary Glass (#23).

The Bumper Strip (#13) is not necessary with the 72” model. (Fig 34.3*)

Attach the Handle (#06) to the Door Glass (#05). (Fig 34)