Installation Guide

10ENIGMA-XO manual Ver 1 Rev 2 03/2018

Fig 3

Fig 4

Door end of guide rail

High spot of disk bushing

measure

glass bracket

disk

TIP: Mark the location of the high spot on the outer surface of the

adjustment disk with a felt tip pen to make adjustment easier to see.

outside

stationary

panel-end

thread

lock

door-end

stopper hole

panel end

3a. Attach the Upper Guide Rail (#03) to the Stationary Glass (#02)

with the Glass Brackets (#07) and tighten the bolts into the holes in

the Upper Guide Rail (#03). Make sure both adjustment disks are

installed in the same direction with the high spot towards the door

end. (see *Note below)

Make sure that the guide rail is attached parallel with the top edge of

the stationary panel glass.

*NOTE: The outer glass bracket disk has an eccentric bushing

for adjustment. Be sure to install both glass bracket disks with

the high spot of the bushing pointed towards the door end of

the guide rail.

3b. Slide the Door Stoppers (#01) onto each end of the Upper

Guide Rail (#03). Secure them using the 4mm Allen Wrench (#11).

Install the panel-end stopper into the pre-drilled stopper hole in

the Upper Guide Rail and apply thread lock to the set screw.

(Fig 3.3) Install the door-end stopper approximately 4” from the end

of the guide rail. (The door-end stopper position will be adjusted

after the door glass is installed).

3c. Slide the Guide Rail Brackets (#08) onto each end of the

Upper Guide Rail (#03) and secure them. Next, assemble the

Wall Bracket (#19) onto the bottom corner of the Stationary

Glass (#02) with the bolt facing into the shower as shown in

Fig 3.5. Use the supplied gaskets to protect the glass.

(Fig. 3 and Fig. 4)